Tools and Accessories Needed for Spackling
Unaesthetic gouges or holes in the drywall are not easily avoidable. Whether moving into a home that was previously lived in by someone else or you are planning to move wall art into your own home, there will come a time when you would need to repair the walls in your home. Most drywall repairs require only a joint compound and a few other tools in order to spackle drywall.You have to also be prepared to repaint or retouch the area that has been repaired. Such minor flaws as small nail holes and dents can be repaired by sanding it clean and then filling the area with a spackling compound made of vinyl. Choose a putty knife that is approximately the size of the blemish. If you need to add more than one layer of the vinyl compound, make sure you allow time for each layer of the application to dry.
Popped nails can be fixed when you tap a pop nail that is beneath the surface of the wall. Then, you should drive a second drywall screw or nail next to it in order to hold the first nail in place. You can fill in the dimples with the joint compound.
How to Fix Holes in the Drywall
Even though holes are easy to make in drywall, they are also pretty easy to fix. First, dent the surface of the drywall using a hammer in order to prevent any voids from being produced. Then use a vinyl spackling compound in order to fill the hole in the drywall. Dampen the hole with a sponge after cleaning it. Using a 3 inch putty knife, apply the compound. Then, draw it smoothly over the dent and flush with the surface of the wall. You must use a new piece of drywall of similar thickness in case the wall has a large dent or hole.
Drywall repair kits are sold separately in case the hole is larger in size or deeper. These kits include simple metal clips that are required to support a replacement piece. Cut the hole in the wall before applying the patch using a saber saw, a utility knife or a jab saw. You could also make your own backer board using a piece of the drywall or plywood. If the hole is very large, then you should use a spackle blade that is about 4 inches in size and apply the compound to the seams with the blade by holding it at 45 degrees. Apply the next layer with a 6-inch knife. However, let there be a gap of at least 24 hours between the applications of each layer. Do the same for the third layer. Only this time, use a 10-inch blade or knife.
Fixing Cracks in the Drywall
Beneath the corner of the drywall is a lightweight metal called the corner bead. Make sure you straighten it out and cover it over again with a little bit of the joint compound. Use a spackle tape to seal all the cracks in the drywall.
Find Out If DESIGN BUILD PLANNERS Is Right For You click here →